L**W
Prints good when it finishes a print
Not terrible filament when you can get it print without breaking. The first half of the spool ran fine but then it started breaking sometimes midway through a print lots of wasted filament. Won't get this brand again.
K**N
1/2 kilo spool but why on a 1 kilo spool?
Nice filament but who were the geniuses who wound it on a 1k spool - this WILL NOT fit my printer that is 1/2kilo only! Not too happy.
J**I
Poor adhesion
Issues from the start. Adhesion to unheated bed is bad, even after glue is applied.Lost a few print due to poor bed adhesion.
A**N
Good buy
Good quality print material overall, have enjoyed using it in my Monoprice printer
M**E
Brittle
Very brittle, pieces break off just unwinding the roll. Once it makes into the printer it works ok though.
K**E
Okay
Purchased because I thought it would fit our Voxel and/or Flashforge Adventurer 3D printer. Unfortunately it did not. Still ok print quality for the price.
Z**T
Ok in a pinch.
Had to have white for a project, and there wasn't much available so I decided to try this.It was brittle, popped, and didn't give the best results. This brand would not be in my top 5 choices.
A**D
Expensive for old, brittle product.
Product was brittle, and appeared to be old. I will not be purchasing this product again.I thought about returning, but I was able to get one print out before it broke apart too much.Better product elsewhere, steer clear of this product.
Trustpilot
1 week ago
3 days ago
